We and our partners use technologies, such as cookies, to recognize you and show you more of what you like. Please read our Privacy Policy to learn more. By using this website you agree to the use of those technologies.
I agree.
Exposing both sides of the film (EBS).
I shot on correct(normal) side first in a sunny/bright day, at ISO400(ISO800 film inside). Below half of the lense was masked with a splitzer. After finished a roll, reverse the film (in a dark-room). Then start shooting on redscale side in a cloudy/rainy day, at ISO200. Upper half was masked with a splitzer. The order of each location is precisely the same as 1st shots. I took notes in details about locations and shot all places with iPhone, to remember locations. Need patience, concentration, and accuracy for this challenge. Plus must be careful with 'gaps' between frames. Have a look at my article about this technique: http://www.lomography.com/magazine/tipster/2013/01/14/tipster-how-to-take-symmetrical-images-with-exposing-both-sides-of-the-film-ebs
Expose lower half first, and set a tripod upside down and expose upper half in the same way as 1st shot.
To turn tripod 180 degrees, I used two panheads.
About 10 seconds each. Using a cable release and black adhesive tape (to mask the light sensor of LC-A+). Vivid blue or purple colours are by trucks decorated with light bulbs. Needed patience and concentration...
I pulled the LC-A+ RL setting to 400ISO, because it was sunny but the result came out a bit under. - This film remind and reduce the sense of missed about old XPRO 100 that came out blueish when you crossprocess it. Love it!
De vez en cuando es bonito perderse por una ruta de senderismo y disfrutar de la naturaleza.
Visita nuestro Blog/visit our blog:
http://www.lomography.es/homes/lola_juanlu/blog/2154-un-dia-100-analogico
